• Easy to operate - single-lever control of dispense, flush and rinse cycle
• Software logic - controls all functions; easy repair with minimum downtime.
• Rugged yet simple construction - structural steel components with two-part catalyzed epoxy paint coating
• Accurate - high resolution weighing and two speed cycle with knob controlled slow speed adjustment · Easy installation - stanchion is telescopic to compensate for change in conveyor height or floor conditions
• Heavy duty air-operated diaphragm pump
• Flexibility - many options to choose from to tailor-make a dispenser for your needs.

Microcomputer - controlled weightmeter with:

• Weight reading 5000# x 1# · NEMA 4 wall-mount enclosure
• Full alpha/numeric keypad and menu-driven programming
• Solid state I/O - optically isolated inputs and outputs eliminate mechanical relays
• Pushbutton zero
• Automatic tare - occurs at the start of each cycle
• Flush mode - allows operator to flush lance and piping with pre-determined quantity of base product/flush material
• Lance misalignment protection - prevents damage if the lance misses the bung
• Battery back-up for tare and set point values
• Alpha/numeric four-row, 40 character LCD display prompts operator
• Serial ASCII output
• Center of zero indication
• Automatic zero tracking
• Product level tracking feature - lance tracks product level down while maintaining a programmable depth

  Flexure Lever Base with:

• Weight reading 5000# x 1# · NEMA 4 wall-mount enclosure · Full alpha/numeric keypad and menu-driven programming · Solid state I/O - optically isolated inputs and outputs eliminate mechanical relays · Pushbutton zero · Automatic tare - occurs at the start of each cycle · Flush mode - allows operator to flush lance and piping with pre-determined quantity of base product/flush material · Lance misalignment protection - prevents damage if the lance misses the bung · Battery back-up for tare and set point values · Alpha/numeric four-row, 40 character LCD display prompts operator · Serial ASCII output · Center of zero indication · Automatic zero tracking · Product level tracking feature - lance tracks product level down while maintaining a programmable depth

• Hazardous Area Protection - to meet Class I, Division I & II requirements
• Bi-directional communications (RS232/422/485) for remote programming
• Data recording - statistical reports
• Drum Rinsing
• Skid-mounted built-in forklift channels for portability
• Steam jacket or heat-tracing
• Stainless steel construction or special coatings
• Base product/flushing material tank with product removal receptacle
• Other options available - contact factory
• Four drum model- fully automatic - single drum models also available